PISO-CAN100U-T

1-Port CAN Universal PCI Card

  • One CAN bus communication port
  • Compatible with CAN specification 2.0 parts A and B
  • On-board optical isolation protection
  • Programmable transfer rate up to 1 Mbps
  • 2500 Vrms photo couple isolation on the CAN bus
  • Jumper select 120Ω terminal resistor for each port
  • Direct memory mapping to the CAN controllers
  • 33MHz 32bit 5V PCI bus (V2.1) plug and play
  • Universal PCI card, supports both 5V and 3.3V PCI bus
  • We have verified to drive 100 CAN nodes at the same time
  • Note: We have verified to drive 100 CAN nodes at the same time via one CAN port of PISO-CAN100U.

Introduction

The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN100U-T can represent an economic solution of an active CAN board. It has one CAN bus communication port with 5-pin screw terminal connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN100U-T uses the new CAN controller Phillips SJA1000T and transceiver 82C250, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.

Applications



• CAN bus communication application
• DeviceNet, CANopen, CAN J1939, SDS(System Wide Network) protocol application
• Control System
• Building Automation
• Factory Automation
• Distributed data acquisition

PISO-CAN100U-T

دانلود فایل

1-Port CAN Universal PCI Card

1400/10/26

Introduction

The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN100U-T can represent an economic solution of an active CAN board. It has one CAN bus communication port with 5-pin screw terminal connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN100U-T uses the new CAN controller Phillips SJA1000T and transceiver 82C250, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.

Applications



• CAN bus communication application
• DeviceNet, CANopen, CAN J1939, SDS(System Wide Network) protocol application
• Control System
• Building Automation
• Factory Automation
• Distributed data acquisition
دانلود فایل
برچسب ها: DeviceNet CAN J1939 communication